Differences

This shows you the differences between two versions of the page.

--- lab_with_ipv6_tunnel [2018/01/19 19:24] – [3.1. Static Configuration] samer
+++ lab_with_ipv6_tunnel [2018/01/19 19:25] (current) – [3.2. Stateless Auto-Configuration] samer
@@ Line 48: / Line 48: @@
 ==== -. Stateless Auto-Configuration ====
-If you want to benefit from the auto-configuration mechanisms in IPv6, you can start a routing daemon on the TEP. This daemon (typical radvd on Debian) will send routing advertisements and enable your lab PC to perform stateless auto-configuration.
+If you want to benefit from the auto-configuration mechanisms in IPv6, you can start a routing daemon on the TEP. This daemon (typically radvd on Debian) will send routing advertisements and enable your lab PC to perform stateless auto-configuration.
 You can install radvd using ''apt-get install radvd'' on the TEP and configure the /64 prefix in ''/etc/radvd.conf'' as follows: