a_networking_lab_on_qos_for_less_than_50_dollars
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
a_networking_lab_on_qos_for_less_than_50_dollars [2017/11/11 19:26] – [3. Software] samer | a_networking_lab_on_qos_for_less_than_50_dollars [2017/11/16 11:01] (current) – [6. Before you Start/Leave] samer | ||
---|---|---|---|
Line 40: | Line 40: | ||
<code bash> | <code bash> | ||
- | pip install matplotlib | ||
apt-get install fping | apt-get install fping | ||
+ | apt-get install python-qt4 | ||
+ | pip install matplotlib | ||
</ | </ | ||
Line 51: | Line 52: | ||
Install VLC as in this | Install VLC as in this | ||
[[https:// | [[https:// | ||
+ | |||
+ | |||
+ | ===== -. Addressing ===== | ||
+ | |||
+ | the addressing plan of the platform is shown in Fig. 2. Both routers have static addresses on their wan and lan interfaces. DHCP is activated on the LAN interfaces and static leases are configured so as to obtain the addresses on the terminals according to the figure. | ||
+ | [{{ : | ||
+ | |||
+ | ===== -. Access and Configuration ===== | ||
+ | |||
+ | SSH is activated on the two Raspberry Pi devices connected to the TP-LINK router. Thus, they can be accesses by typing '' | ||
+ | |||
+ | For both routers, SSH is also activated, and they can be accessed by any SSH client on the platform. For easiness, you can also connect to the WiFi interfaces (OpenWrt and GL-iNet SSID) and configure the routers form your personal laptop. The root password for GL-iNet is '' | ||
+ | |||
+ | ===== -. Before you Leave ===== | ||
+ | |||
+ | Before you leave, make sure to go through the following steps. | ||
+ | * Gracefully shutdown the raspberry pi modules with '' | ||
+ | * Switch off the TP-LINK and remove the USB power cable from the GL-iNet. | ||
+ | * Power off the laptop. |
a_networking_lab_on_qos_for_less_than_50_dollars.txt · Last modified: 2017/11/16 11:01 by samer