Differences

This shows you the differences between two versions of the page.

--- deploying_lorawan [2017/01/04 11:13] – [2.1. Single Channel Gateway] samer
+++ deploying_lorawan [2017/04/29 17:45] – [1.1. Autonomo with LoRaBee] samer
@@ Line 8: / Line 8: @@
 ==== -. Autonomo with LoRaBee ====
+For the end-devices in the LoRaWAN platform, we will use an Autonomo board with a LoRaBee holding the Microchip RN2483 module. According to [[http://shop.sodaq.com]], Autonomo is a matchbox-sized powerhouse which uses the new Atmel Cortex M0+ 32bit micro controller. It can be powered by a smartphone-sized solar panel.
+In order to configure the end-
 ==== -. Arduino with Dragino Shield ====
@@ Line 15: / Line 18: @@
 The single channel gateway includes a LoRa transmission module (Dragino Shield) connected to a Raspberry Pi (2 or 3) as shown in Figure 1. Communication between the two modules is done over an SPI interface.
-[{{ :2017-01-04_11.34.54.jpg?direct&200 |Figure 2. LoRa single channel gateway}}]
+[{{ :2017-01-04_11.34.54.jpg?direct&300 |Figure 2. LoRa single channel gateway}}]
 In order to assemble the gateway, start by making the wire connections: the connection pins are identified in Figures 2 and 3.
@@ Line 37: / Line 40: @@
 </code>
-Now you can compile and run the packet forwarder as root.
+Compile the packet forwarder:
 <code bash>
 make all
-nohup ./single_chan_pkt_fwd &
 </code>
-<codedoc toggle description>
+For gcc version 4.6.3, a compilation error results in the following warning ''unrecognized command line option '-std=c++11'''. Replace ''-std=c++11'' by ''-std=c++0x'' in the Makefile and recompile:
+<code>
+CFLAGS = -std=c++0x -c -Wall -I include/
+</code>
+Now, you need to configure the single channel packet forwarder. This is done in the ''global_conf.json'' configuration file. Particularly, you need to choose the channel, the spreading factor, the pins for SPI communication, and the address of the backend server. Note that you can specify multiple backends for testing purposes.
+<file | global_config.json>
 {
   "SX127x_conf":
@@ Line 84: / Line 93: @@
   }
 }
-</codedoc>
+</file>
+Finally, you can run the packet forwarder as root!
 <code bash>
-gcc version 4.6.3
+nohup ./single_chan_pkt_fwd &
-unrecognized command line option '-std=c++11'
-CFLAGS = -std=c++0x -c -Wall -I include/
 </code>
 ==== -. Kerlink IoT Station ====