Differences

This shows you the differences between two versions of the page.

--- deploying_lorawan [2016/12/20 12:27] – [2.1. Single Channel Gateway] samer
+++ deploying_lorawan [2016/12/20 12:37] – [2.1. Single Channel Gateway] samer
@@ Line 13: / Line 13: @@
 ==== -. Single Channel Gateway ====
-The single channel gateway includes a LoRa transmission module (the Dragino Shield) connected to a Raspberry Pi (2 or 3). The connection pins are identified in Figures 2 and 3. Communication is done on an SPI communication interface.
+The single channel gateway includes a LoRa transmission module (Dragino Shield) connected to a Raspberry Pi (2 or 3). Communication is done over an SPI interface.
+Start by making the correction connection between the modules: the connection pins are identified in Figures 2 and 3.
 [{{ :schema-single-channel-pi3.png?direct&300 |Figure 2. Dragino pin mapping}}]
 [{{ :schema-pins-pi3.png?direct&300 |Figure 3. Raspberry pi 3 pins}}]
-After making the correct connection, you need to install the packet forwarder software on the Raspberry Pi. The source code is available on: [[https://github.com/samerlahoud/single_chan_pkt_fwd]]. In order to proceed, you need to :
+Now you can connect the Raspberry Pi to the Internet and install the packet forwarding software. The source code of the single channel packet forwarder is available on: [[https://github.com/samerlahoud/single_chan_pkt_fwd]]. In order to install it, you need to:
   * Enable SPI on the Raspberry Pi using raspi-config
   * Download and unzip the source code: