Differences

This shows you the differences between two versions of the page.

--- deploying_lorawan [2016/12/20 11:00] – [2.1. Single Channel Gateway] samer
+++ deploying_lorawan [2016/12/20 12:37] – [2.1. Single Channel Gateway] samer
@@ Line 13: / Line 13: @@
 ==== -. Single Channel Gateway ====
-The single channel gateway includes a LoRa transmission module (the Dragino Shield) connected to a Raspberry Pi (2 or 3). The connection pins are identified in Figures 2 and 3. Communication is done on an SPI communication interface.
+The single channel gateway includes a LoRa transmission module (Dragino Shield) connected to a Raspberry Pi (2 or 3). Communication is done over an SPI interface.
+Start by making the correction connection between the modules: the connection pins are identified in Figures 2 and 3.
 [{{ :schema-single-channel-pi3.png?direct&300 |Figure 2. Dragino pin mapping}}]
 [{{ :schema-pins-pi3.png?direct&300 |Figure 3. Raspberry pi 3 pins}}]
-SPI needs to be enabled on the Raspberry Pi (use raspi-config)
+Now you can connect the Raspberry Pi to the Internet and install the packet forwarding software. The source code of the single channel packet forwarder is available on: [[https://github.com/samerlahoud/single_chan_pkt_fwd]]. In order to install it, you need to:
-WiringPi: a GPIO access library written in C for the BCM2835 used in the Raspberry Pi. sudo apt-get install wiringpi see http://wiringpi.com
+  * Enable SPI on the Raspberry Pi using raspi-config
-Run packet forwarder as root
+  * Download and unzip the source code:
+<code bash>
+wget https://github.com/hallard/single_chan_pkt_fwd/archive/master.zip
+unzip master.zip
+</code>
+  * Install the wiring library:
+<code bash>
+apt-get update
+apt-get install wiring
+</code>
+  * Compile and run the packet forwarder as root.
+<code bash>
+gcc version 4.6.3
+unrecognized command line option '-std=c++11'
+CFLAGS = -std=c++0x -c -Wall -I include/
+</code>
 ==== -. Kerlink IoT Station ====