Differences

This shows you the differences between two versions of the page.

--- deploying_lorawan [2016/10/16 22:34] – samer
+++ deploying_lorawan [2016/12/20 12:37] – [2.1. Single Channel Gateway] samer
@@ Line 1: / Line 1: @@
 ====== Deploying an End-to-End LoRaWAN Platform ======
-[{{ :e2e-lorawan.png?direct&750 | Architecture of the LoRaWAN Platform}}]
+Starting from September 2016, Saint-Joseph University of Beirut (USJ) will be deploying the first academic [[http://www.semtech.com/wireless-rf/internet-of-things/what_is_lora.html | LoRa]] network in Lebanon. The network will support monitoring of micro-climate conditions in vineyards. Here below you can find a detailed description of the experimental platform implementing an end-to-end LoRaWAN solution.
+[{{ :e2e-lorawan.png?direct&750 | Figure 2. Architecture of the LoRaWAN Platform}}]
+===== -. End-nodes =====
+==== -. Autonomo with LoRaBee ====
+==== -. Arduino with Dragino Shield ====
+===== -. Gateways =====
+==== -. Single Channel Gateway ====
+The single channel gateway includes a LoRa transmission module (Dragino Shield) connected to a Raspberry Pi (2 or 3). Communication is done over an SPI interface.
+Start by making the correction connection between the modules: the connection pins are identified in Figures 2 and 3.
+[{{ :schema-single-channel-pi3.png?direct&300 |Figure 2. Dragino pin mapping}}]
+[{{ :schema-pins-pi3.png?direct&300 |Figure 3. Raspberry pi 3 pins}}]
+Now you can connect the Raspberry Pi to the Internet and install the packet forwarding software. The source code of the single channel packet forwarder is available on: [[https://github.com/samerlahoud/single_chan_pkt_fwd]]. In order to install it, you need to:
+  * Enable SPI on the Raspberry Pi using raspi-config
+  * Download and unzip the source code:
+<code bash>
+wget https://github.com/hallard/single_chan_pkt_fwd/archive/master.zip
+unzip master.zip
+</code>
+  * Install the wiring library:
+<code bash>
+apt-get update
+apt-get install wiring
+</code>
+  * Compile and run the packet forwarder as root.
+<code bash>
+gcc version 4.6.3
+unrecognized command line option '-std=c++11'
+CFLAGS = -std=c++0x -c -Wall -I include/
+</code>
+==== -. Kerlink IoT Station ====
+===== -. Backend =====
+==== -. Loraserver ====
+==== -. The Things Network ====
+===== -. Applications =====
+==== -. MQTT spy ====
+==== -. Emoncms ====