Differences

This shows you the differences between two versions of the page.

--- networking-lab-setting-with-gns3 [2019/02/12 16:28] – samer
+++ networking-lab-setting-with-gns3 [2019/02/25 10:24] – [4. Adding a Cisco Router] samer
@@ Line 8: / Line 8: @@
 GNS3 is already downloaded on the Lab PCs. If you need to install it on your PC, you should create an account and download it from [[https://www.gns3.com/software/download]]. Make sure to choose the right version for your operating system. Moreover, during the first steps of the installation, choose to ''Run only legacy IOS'' as shown below.
-{{ :gns3.png?nolink&300 |}}
+{{ :gns3.png?nolink&600 |}}
-Copy the file ''c3725-adventerprisek9-mz.124-15.T14.image'' from the folder ''commun'' to your local ''Downloads'' folder.
+Copy the file ''c3725-adventerprisek9-mz.124-15.T14.image'' from Moodle or from the folder ''commun'' to your local ''Downloads'' folder.
 ===== -. Basic Configuration =====
@@ Line 17: / Line 17: @@
 {{ :gns3-capture1.png?nolink&600 |}}
-Now proceed to add an IOS router.
+Configure the local server.
-{{ :gns3-3.JPG?nolink&300 |}}
+{{ :gns3-4.JPG?nolink&600 |}}
+And click to add an IOS router as shown hereafter.
+{{ :gns3-3.JPG?nolink&350 |}}
-{{ :gns3-4.JPG?nolink&300 |}}
 ===== -. Adding a Cisco Switch =====
@@ Line 41: / Line 44: @@
 ===== -. Adding a Cisco Router =====
-In order to add a Cisco router to GNS3, start by copying the file ''c7200-advipservicesk9-mz.150-1.M.bin'' from the folder ''commun'' to your local Downloads folder. Now, go to ''Preferences'', then ''IOS Routers'' and click on ''New''.
+In order to add a Cisco router to GNS3, start by copying the file ''c7200-advipservicesk9-mz.150-1.M.bin'' from Moodle or from the folder ''commun'' to your local Downloads folder. Now, go to ''Preferences'', then ''IOS Routers'' and click on ''New''.
 {{ :router-capture-1.PNG?nolink&600 |}}