Differences

This shows you the differences between two versions of the page.

--- networking-lab-setting-with-gns3 [2018/04/13 14:57] – [4. Adding a Cisco Router] samer
+++ networking-lab-setting-with-gns3 [2019/02/25 10:24] – [4. Adding a Cisco Router] samer
@@ Line 10: / Line 10: @@
 {{ :gns3.png?nolink&600 |}}
-Copy the file ''c3725-adventerprisek9-mz.124-15.T14.image'' from the folder ''commun'' to your local ''Downloads'' folder.
+Copy the file ''c3725-adventerprisek9-mz.124-15.T14.image'' from Moodle or from the folder ''commun'' to your local ''Downloads'' folder.
 ===== -. Basic Configuration =====
@@ Line 17: / Line 17: @@
 {{ :gns3-capture1.png?nolink&600 |}}
-Now proceed to add an IOS router.
+Configure the local server.
-{{ :gns3-capture2.png?nolink&600 |}}
+{{ :gns3-4.JPG?nolink&600 |}}
+And click to add an IOS router as shown hereafter.
+{{ :gns3-3.JPG?nolink&350 |}}
 ===== -. Adding a Cisco Switch =====
@@ Line 40: / Line 44: @@
 ===== -. Adding a Cisco Router =====
-In order to add a Cisco router to GNS3, start by copying the file ''c7200-advipservicesk9-mz.150-1.M.bin'' from the folder ''commun'' to your local Downloads folder. Now, go to ''Preferences'', Then ''IOS Routers'' and click on ''New''. Click on ''New Image'', then browse and select the ''c7200-advipservicesk9-mz.150-1.M.bin'' in your ''Downloads'' folder. Click yes to copy it to the default images library.
+In order to add a Cisco router to GNS3, start by copying the file ''c7200-advipservicesk9-mz.150-1.M.bin'' from Moodle or from the folder ''commun'' to your local Downloads folder. Now, go to ''Preferences'', then ''IOS Routers'' and click on ''New''.
 {{ :router-capture-1.PNG?nolink&600 |}}
+Click on ''New Image'', then browse and select the ''c7200-advipservicesk9-mz.150-1.M.bin'' in your ''Downloads'' folder. Click ''yes'' to copy it to the default images library.
 {{ :router-capture-2.PNG?nolink&600 |}}
-Click on Idle-PC finder and wait for the process to complete.
+Make sure to add Fast Ethernet interfaces to your router as in the image below.
-Make sure to add Fast Ethernet interfaces to your router as in the image below.
 {{ :router-capture-3.PNG?nolink&600 |}}
-Apply to validate the new device parameters. Now you are set to start using Cisco routers with GNS3.
+Click on Idle-PC finder and wait for the process to complete. Finally, apply to validate the new device parameters. Now you are set to start using Cisco routers with GNS3.
 ===== -. Starting a New Project =====