Differences

This shows you the differences between two versions of the page.

--- networking-lab-setting-with-gns3 [2018/03/03 15:20] – [6. Tips and Hints] samer
+++ networking-lab-setting-with-gns3 [2019/02/25 10:24] – [4. Adding a Cisco Router] samer
@@ Line 6: / Line 6: @@
 ===== -. Software Download =====
-GNS3 is already downloaded on the Lab PCs. If you need to install it on your PC, you should create an account and download it from [[https://www.gns3.com/software/download]]. Make sure to choose the right version for your operating system.
+GNS3 is already downloaded on the Lab PCs. If you need to install it on your PC, you should create an account and download it from [[https://www.gns3.com/software/download]]. Make sure to choose the right version for your operating system. Moreover, during the first steps of the installation, choose to ''Run only legacy IOS'' as shown below.
-Copy the file ''c3725-adventerprisek9-mz.124-15.T14.image'' from the folder ''commun'' to your local ''Downloads'' folder.
+{{ :gns3.png?nolink&600 |}}
+Copy the file ''c3725-adventerprisek9-mz.124-15.T14.image'' from Moodle or from the folder ''commun'' to your local ''Downloads'' folder.
 ===== -. Basic Configuration =====
@@ Line 15: / Line 17: @@
 {{ :gns3-capture1.png?nolink&600 |}}
-Now proceed to add an IOS router.
+Configure the local server.
-{{ :gns3-capture2.png?nolink&600 |}}
+{{ :gns3-4.JPG?nolink&600 |}}
+And click to add an IOS router as shown hereafter.
+{{ :gns3-3.JPG?nolink&350 |}}
 ===== -. Adding a Cisco Switch =====
@@ Line 35: / Line 41: @@
 Apply to validate the new device parameters. Now you are set to start using Cisco switches with GNS3.
+===== -. Adding a Cisco Router =====
+In order to add a Cisco router to GNS3, start by copying the file ''c7200-advipservicesk9-mz.150-1.M.bin'' from Moodle or from the folder ''commun'' to your local Downloads folder. Now, go to ''Preferences'', then ''IOS Routers'' and click on ''New''.
+{{ :router-capture-1.PNG?nolink&600 |}}
+Click on ''New Image'', then browse and select the ''c7200-advipservicesk9-mz.150-1.M.bin'' in your ''Downloads'' folder. Click ''yes'' to copy it to the default images library.
+{{ :router-capture-2.PNG?nolink&600 |}}
+Make sure to add Fast Ethernet interfaces to your router as in the image below.
+{{ :router-capture-3.PNG?nolink&600 |}}
+Click on Idle-PC finder and wait for the process to complete. Finally, apply to validate the new device parameters. Now you are set to start using Cisco routers with GNS3.
 ===== -. Starting a New Project =====
@@ Line 65: / Line 87: @@
   * Click on the abc button to show the interface names on the network.
   * Right click on any link to start capturing packets using Wireshark.
-</WRAP>
-===== -. TBD =====
-<WRAP center round todo 60%>
-  * Adding a Router
 </WRAP>