lorawan_downlink
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
lorawan_downlink [2017/12/12 08:24] – [4.1. Autonomo with LoRaBee] samer | lorawan_downlink [2017/12/13 17:30] – [5. Selecting the Receive Windows] samer | ||
---|---|---|---|
Line 63: | Line 63: | ||
This sketch {{ :: | This sketch {{ :: | ||
- | |||
- | |||
- | ==== -. Arduino with Dragino Shield ==== | ||
- | Devices in the LoRaWAN platform can also be implemented on Arduino boards with Dragino shields. The combined module as well as the basic configuration steps are presented in [[simple_lora_prototype|Simple Prototype of LoRa Communications]]. Similarly to the Autonomo device, you can download the following sketch {{ :: | ||
<code c++> | <code c++> | ||
Line 98: | Line 94: | ||
} | } | ||
</ | </ | ||
+ | ==== -. Arduino with Dragino Shield ==== | ||
+ | Devices in the LoRaWAN platform can also be implemented on Arduino boards with Dragino shields. The combined module as well as the basic configuration steps are presented in [[simple_lora_prototype|Simple Prototype of LoRa Communications]]. Similarly to the Autonomo device, you can download the following sketch {{ :: | ||
+ | <code c++> | ||
+ | case EV_TXCOMPLETE: | ||
+ | Serial.println(F(" | ||
+ | if (LMIC.dataLen) { | ||
+ | // data received in rx slot after tx | ||
+ | Serial.print(F(" | ||
+ | Serial.write(LMIC.frame + LMIC.dataBeg, | ||
+ | Serial.println(); | ||
+ | } | ||
+ | </ | ||
===== -. Selecting the Receive Windows ===== | ===== -. Selecting the Receive Windows ===== | ||
Line 109: | Line 117: | ||
[{{ undefined: | [{{ undefined: | ||
+ | |||
+ | <WRAP center round tip 60%> | ||
+ | Without configuring the receive window, with OTAA mode, autonomo is receiving on RX1. | ||
+ | </ |
lorawan_downlink.txt · Last modified: 2021/08/28 09:53 by samer