wikiroute

networking recipes

User Tools

Site Tools


lab_with_ipv6_tunnel

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
lab_with_ipv6_tunnel [2018/01/19 19:24]
samer [3.1. Static Configuration]
lab_with_ipv6_tunnel [2018/01/19 19:25] (current)
samer [3.2. Stateless Auto-Configuration]
Line 48: Line 48:
 ==== -. Stateless Auto-Configuration ==== ==== -. Stateless Auto-Configuration ====
  
-If you want to benefit from the auto-configuration mechanisms in IPv6, you can start a routing daemon on the TEP. This daemon (typical ​radvd on Debian) will send routing advertisements and enable your lab PC to perform stateless auto-configuration.+If you want to benefit from the auto-configuration mechanisms in IPv6, you can start a routing daemon on the TEP. This daemon (typically ​radvd on Debian) will send routing advertisements and enable your lab PC to perform stateless auto-configuration.
 You can install radvd using ''​apt-get install radvd''​ on the TEP and configure the /64 prefix in ''/​etc/​radvd.conf''​ as follows: ​ You can install radvd using ''​apt-get install radvd''​ on the TEP and configure the /64 prefix in ''/​etc/​radvd.conf''​ as follows: ​
   ​   ​
lab_with_ipv6_tunnel.txt ยท Last modified: 2018/01/19 19:25 by samer