wikiroute

networking recipes

User Tools

Site Tools

Trace:
lab_with_ipv6_tunnel

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
lab_with_ipv6_tunnel [2018/01/19 19:24] – [3. Lab Platform Configuration] samerlab_with_ipv6_tunnel [2018/01/19 19:24] – [3.1. Static Configuration] samer
Line 41: Line 41:
 </code> </code>
 ==== -. Static Configuration ==== ==== -. Static Configuration ====
-On a PC in your lab, you can configure a static IPv6 address chosen from your /64 routed prefix (as shown on the Tunnel details information page). Moreover, you should add a default route using the link-local address of the interface e0 of TEP as in the following:+On any PC in your lab, you can configure a static IPv6 address chosen from your /64 routed prefix. Moreover, you should add a default route using the link-local address of the e0 interface of the TEP as in the following:
 <code bash> <code bash>
 ip -6 addr add Routed_Prefix::X/64 dev PC_interface ip -6 addr add Routed_Prefix::X/64 dev PC_interface
lab_with_ipv6_tunnel.txt · Last modified: 2018/01/19 19:25 by samer