ipv6_tunnel_at_home
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
ipv6_tunnel_at_home [2015/04/04 18:10] – samer | ipv6_tunnel_at_home [2015/04/04 18:31] (current) – [1.1- IPv4 Configuration] samer | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== -- Summary | + | ====== IPv6 Tunnel on OpenWrt ====== |
+ | |||
+ | ===== -- Summary===== | ||
The objective of this platform is to connect your home network to the Internet using an IPv6 tunnel provided by [[ https:// | The objective of this platform is to connect your home network to the Internet using an IPv6 tunnel provided by [[ https:// | ||
- | * The Ethernet interface is connected to you home set-top box. | + | * The Ethernet interface is connected to your home set-top box. |
- | * The WLAN interface is used to interconnect all home equipments using IPv6. | + | * The WiFi interface creates a local area network and connects the home equipment. |
+ | ===== -- IPv4 Configuration===== | ||
+ | Start by configuring Ethernet and WLAN interfaces on the MR3020 in two different IP networks. As the Ethernet | ||
- | ====== -- Global Scenarion ====== | + | <WRAP center round tip 100%> |
- | The following assumptions determine | + | Note that in OpenWrt, |
- | - The | + | </ |
- | Start by configuring the Ethernet and the WLAN interfaces | + | |
<file autoconf / | <file autoconf / | ||
Line 28: | Line 32: | ||
option ipaddr ' | option ipaddr ' | ||
option netmask ' | option netmask ' | ||
- | option ip6addr ' | + | option ip6addr ' |
</ | </ | ||
Line 118: | Line 122: | ||
option dest wan | option dest wan | ||
</ | </ | ||
+ | ==== -- IPv6 Configuration==== | ||
<code bash> | <code bash> | ||
opkg update && opkg install aiccu radvd | opkg update && opkg install aiccu radvd |
ipv6_tunnel_at_home.1428163847.txt.gz · Last modified: 2015/04/04 18:10 by samer