ipv6_tunnel_at_home
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
ipv6_tunnel_at_home [2015/04/04 17:01] – samer | ipv6_tunnel_at_home [2015/04/04 18:31] (current) – [1.1- IPv4 Configuration] samer | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | Start by configuring | + | ====== IPv6 Tunnel on OpenWrt ====== |
+ | |||
+ | ===== -- Summary===== | ||
+ | |||
+ | The objective of this platform is to connect your home network to the Internet using an IPv6 tunnel provided | ||
+ | * The Ethernet | ||
+ | * The WiFi interface creates a local area network | ||
+ | ===== -- IPv4 Configuration===== | ||
+ | Start by configuring Ethernet and WLAN interfaces on the MR3020 in two different | ||
+ | |||
+ | <WRAP center round tip 100%> | ||
+ | Note that in OpenWrt, the configuration uses logical names for interfaces, such as '' | ||
+ | </ | ||
<file autoconf / | <file autoconf / | ||
Line 20: | Line 32: | ||
option ipaddr ' | option ipaddr ' | ||
option netmask ' | option netmask ' | ||
- | option ip6addr ' | + | option ip6addr ' |
</ | </ | ||
Line 110: | Line 122: | ||
option dest wan | option dest wan | ||
</ | </ | ||
+ | ==== -- IPv6 Configuration==== | ||
<code bash> | <code bash> | ||
opkg update && opkg install aiccu radvd | opkg update && opkg install aiccu radvd | ||
Line 166: | Line 178: | ||
# Login information (defaults: none) | # Login information (defaults: none) | ||
- | username | + | username |
- | password | + | password |
# Protocol and server to use for setting up the tunnel (defaults: none) | # Protocol and server to use for setting up the tunnel (defaults: none) |
ipv6_tunnel_at_home.1428159699.txt.gz · Last modified: 2015/04/04 17:01 by samer