Differences

This shows you the differences between two versions of the page.

--- exploring_lorawan [2019/11/06 10:13] – [4. Applications] samer
+++ exploring_lorawan [2020/11/11 22:17] – samer
@@ Line 42: / Line 42: @@
 Devices in the LoRaWAN platform are implemented on Arduino boards with Dragino shields. The combined module as well as the basic configuration steps are presented in [[exploring_lora|Exploring LoRa lab]].
-Start by verifying the installation on your PC of the latest Arduino IDE. Unzip the Arduino {{ :arduino-lmic-mcci.zip |LMIC library}} and copy it to your sketchbook library folder as detailed in [[https://www.arduino.cc/en/Guide/Libraries]]. Then, download and open the example sketch {{ :example-code-idoe-iot-lab.zip |example-code-idoe-iot-lab.ino}} with Arduino IDE.
+Start by verifying the installation on your PC of the latest Arduino IDE. Unzip the Arduino {{ :mcci_lorawan_lmic_library.zip |LMIC library}} and copy it to your sketchbook library folder as detailed in [[https://www.arduino.cc/en/Guide/Libraries]]. Then, download and open the example sketch {{ :example-code-idoe-iot-lab.zip |example-code-idoe-iot-lab.ino}} with Arduino IDE.
 Now you should configure your device with the same identifiers ''DEVEUI'' and ''APPKEY'' as in the backend:
@@ Line 85: / Line 85: @@
 Now you are ready to compile the sketch and upload it to the LoRaWAN device. Connect the device to a USB port on your PC, choose the board type as presented in [[exploring_lora|Exploring LoRa lab]] and select the corresponding port. Compile and upload!
+<WRAP center round todo 60%>
+Debugging causes memory problems on Arduino One and duemilanove. Debug level should stay 0.
+</WRAP>
 Open the serial monitor in the Arduino IDE at 115200 baud and analyse the debug messages.
@@ Line 103: / Line 107: @@
 <WRAP center round todo 60%>
-Prefer mqtt-fx and put user credentials
+Prefer mqtt-fx or mqtt-explorer and put user credentials
 </WRAP>
@@ Line 161: / Line 165: @@
 ==== -. The Sensor Challenge ====
 I can use different sensors to send data from the device: PIR, moisture, temperature, light, etc.
+<WRAP center round important 100%>
+When connecting sensors, check the pin mapping for unused pins https://wiki.dragino.com/index.php?title=Lora_Shield
+</WRAP>