exploring_lorawan
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| exploring_lorawan [2019/11/06 10:13] – [4. Applications] samer | exploring_lorawan [2020/03/31 17:45] – [4. Applications] samer | ||
|---|---|---|---|
| Line 85: | Line 85: | ||
| Now you are ready to compile the sketch and upload it to the LoRaWAN device. Connect the device to a USB port on your PC, choose the board type as presented in [[exploring_lora|Exploring LoRa lab]] and select the corresponding port. Compile and upload! | Now you are ready to compile the sketch and upload it to the LoRaWAN device. Connect the device to a USB port on your PC, choose the board type as presented in [[exploring_lora|Exploring LoRa lab]] and select the corresponding port. Compile and upload! | ||
| + | |||
| + | <WRAP center round todo 60%> | ||
| + | Debugging causes memory problems on Arduino One and duemilanove. Debug level should stay 0. | ||
| + | </ | ||
| Open the serial monitor in the Arduino IDE at 115200 baud and analyse the debug messages. | Open the serial monitor in the Arduino IDE at 115200 baud and analyse the debug messages. | ||
| Line 103: | Line 107: | ||
| <WRAP center round todo 60%> | <WRAP center round todo 60%> | ||
| - | Prefer mqtt-fx and put user credentials | + | Prefer mqtt-fx |
| </ | </ | ||
| Line 161: | Line 165: | ||
| ==== -. The Sensor Challenge ==== | ==== -. The Sensor Challenge ==== | ||
| I can use different sensors to send data from the device: PIR, moisture, temperature, | I can use different sensors to send data from the device: PIR, moisture, temperature, | ||
| + | <WRAP center round important 100%> | ||
| + | When connecting sensors, check the pin mapping for unused pins https:// | ||
| + | </ | ||
exploring_lorawan.txt · Last modified: 2021/11/02 06:31 by samer