exploring_lorawan
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
exploring_lorawan [2019/11/06 10:13] – [4. Applications] samer | exploring_lorawan [2019/11/28 07:38] – [5.4. The Sensor Challenge] samer | ||
---|---|---|---|
Line 85: | Line 85: | ||
Now you are ready to compile the sketch and upload it to the LoRaWAN device. Connect the device to a USB port on your PC, choose the board type as presented in [[exploring_lora|Exploring LoRa lab]] and select the corresponding port. Compile and upload! | Now you are ready to compile the sketch and upload it to the LoRaWAN device. Connect the device to a USB port on your PC, choose the board type as presented in [[exploring_lora|Exploring LoRa lab]] and select the corresponding port. Compile and upload! | ||
+ | |||
+ | <WRAP center round todo 60%> | ||
+ | Debugging causes memory problems on Arduino One and duemilanove. Debug level should stay 0. | ||
+ | </ | ||
Open the serial monitor in the Arduino IDE at 115200 baud and analyse the debug messages. | Open the serial monitor in the Arduino IDE at 115200 baud and analyse the debug messages. | ||
Line 161: | Line 165: | ||
==== -. The Sensor Challenge ==== | ==== -. The Sensor Challenge ==== | ||
I can use different sensors to send data from the device: PIR, moisture, temperature, | I can use different sensors to send data from the device: PIR, moisture, temperature, | ||
+ | <WRAP center round important 100%> | ||
+ | When connecting sensors, check the pin mapping for unused pins https:// | ||
+ | </ | ||
exploring_lorawan.txt · Last modified: 2021/11/02 06:31 by samer