Differences

This shows you the differences between two versions of the page.

--- ipv6_tunnel_at_home [2015/04/04 18:13] – [- Summary] samer
+++ ipv6_tunnel_at_home [2015/04/04 18:31] (current) – [1.1- IPv4 Configuration] samer
@@ Line 1: / Line 1: @@
+====== IPv6 Tunnel on OpenWrt ======
 ===== -- Summary=====
 The objective of this platform is to connect your home network to the Internet using an IPv6 tunnel provided by [[ https://www.sixxs.net | sixxs]]. A TP-Link MR3020 router is used as the tunnel endpoint:
-  * The Ethernet interface is connected to you home set-top box.
+  * The Ethernet interface is connected to your home set-top box.
-  * The WLAN interface is used to interconnect all home equipments using IPv6.
+  * The WiFi interface creates a local area network and connects the home equipment.
-====== -- Global Scenarion ======
+===== -- IPv4 Configuration=====
-The following assumptions determine the scenario of this deployement
+Start by configuring Ethernet and WLAN interfaces on the MR3020 in two different IP networks. As the Ethernet interface is connected to the set-top box, it is important to adapt the following configuration to your environment by choosing an appropriate subnet and gateway. The WiFi interface has an address in a subnet of your choice.
-  - The
-Start by configuring the Ethernet and the WLAN interfaces on the MR3020 in two different IP networks.
+<WRAP center round tip 100%>
+Note that in OpenWrt, the configuration uses logical names for interfaces, such as ''wan'' for ''eth0''.
+</WRAP>
 <file autoconf /etc/config/network>
@@ Line 28: / Line 32: @@
         option ipaddr '192.168.66.1'
         option netmask '255.255.255.0'
-        option ip6addr '2a01:240:fe00:80ab::1/64'
+        option ip6addr '2a01:240:xxxx:yyyy::1/64'
 </file>
@@ Line 118: / Line 122: @@
         option dest             wan
 </file>
+==== -- IPv6 Configuration====
 <code bash>
 opkg update && opkg install aiccu radvd