qos_project
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| qos_project [2017/11/29 10:43] – [6. [CO2] Implementing the Applications and Tools] carine | qos_project [2017/11/29 10:46] – [6. [CO2] Implementing the Applications and Tools] enwan | ||
|---|---|---|---|
| Line 164: | Line 164: | ||
| -To activate iperf3: | -To activate iperf3: | ||
| - | * On a Server | + | * On the server |
| - | * On a Client | + | * On the client |
| -To visualize UDP trafic with a specific bandwidth: | -To visualize UDP trafic with a specific bandwidth: | ||
| - | * On the Client | + | * On the client |
| - | Here we set the bandwidth with UDP to 2Mbit/s. | + | Here we set the bandwidth with UDP to 2Mbit/s. |
| Note that by default ,UDP sets the bandwidth to 1Mbit/s | Note that by default ,UDP sets the bandwidth to 1Mbit/s | ||
| -To extend the transmission time(second) as well as the number packets sent: | -To extend the transmission time(second) as well as the number packets sent: | ||
| - | *On the Client side: iperf3 -c 192.168.200.192 -t 15 | + | *On the Client side: <code bash> |
| - | Note that by default, iperf3 sets the time to 10seconds | + | Note that by default, iperf3 sets the time to 10 seconds |
| -To reverse mode(server sends, client receives): | -To reverse mode(server sends, client receives): | ||
qos_project.txt · Last modified: 2021/08/28 09:58 by samer