Differences

This shows you the differences between two versions of the page.

--- qos_project [2017/11/29 08:59] – [5. [CO1] Connecting the Platform] samer
+++ qos_project [2017/11/29 09:05] – [5. [CO1] Connecting the Platform] samer
@@ Line 97: / Line 97: @@
 </code>
-On the two routing devices, the configuration is given in the ''/etc/config/network'' files as on a typical OpenWrt system.
+We note on the two routers that static routes are used in order to give access to the two LANs. Particularly, the configuration of the routers is given in the ''/etc/config/network'' files as on a typical OpenWrt system.
+As given below, the configuration of the TP-Link router shows the static addressing of the interface ''eth0'' (LAN interface) and the interface ''eth1'' (WAN interface). We also note the section ''route'' that configures a static routers towards the LAN connected to the TP-LINK router.
 <file bash /etc/config/network>
+#Configuration of LAN interface:
-#Configurations on TP-LINK router
-#Configuration of LAN interface :
 config interface 'lan'
         option type 'bridge'
@@ Line 113: / Line 111: @@
         option ip6assign '60'
-#Configuration of WAN interface :
+#Configuration of WAN interface:
 config interface 'wan'
         option ifname 'eth1'
@@ Line 129: / Line 126: @@
         option netmask '255.255.255.0'
         option gateway '10.0.0.1'
 </file>
-<file bash /etc/config/network>
-#Configuration of GL-iNET:
-All the network configuration on both routers (routing & addressing) are taken from /etc/config/network:
-On router GL-iNET, /etc/config/network shows the following:
+Similarly, the configuration of the GL-iNET router
+<file bash /etc/config/network>
 config interface 'lan'
         option force_link '1'