qos_project
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
qos_project [2017/11/23 14:27] – [5. [CO1] Connecting the Platform] samer | qos_project [2017/11/29 08:52] – [5. [CO1] Connecting the Platform] samer | ||
---|---|---|---|
Line 65: | Line 65: | ||
===== -. [CO1] Connecting the Platform ===== | ===== -. [CO1] Connecting the Platform ===== | ||
- | <WRAP center round tip 100%> | + | |
Describe and analyze the basic steps for ensuring the platform connectivity: | Describe and analyze the basic steps for ensuring the platform connectivity: | ||
+ | <WRAP center round info 100%> | ||
+ | * Accomplished | ||
+ | * Enable end-to-end communication | ||
+ | * Analyse the addressing and routing (routing tables, DHCP, etc.) | ||
+ | * Exceeded | ||
+ | * Identify the necessary commands and configurations for enabling end-to-end communication | ||
+ | | ||
+ | </ | ||
+ | In order to analyse the addressing and routing on the platform, we need to look carefully on the interface configuration and routing tables of the different devices. | ||
+ | Let us start with the routing devices. The routing table of the GL-iNet is shown using the command ``ip route`` and gives the following: | ||
- | </WRAP> | + | <code bash> |
+ | 10.0.0.0/24 dev eth0 proto kernel | ||
+ | 192.168.8.0/ | ||
+ | 192.168.100.0/ | ||
+ | 192.168.200.0/ | ||
+ | 10.0.0.2 of the TP-LINK router | ||
+ | </ | ||
+ | |||
+ | <code bash> | ||
+ | |||
+ | Routing table of GL-iNet: | ||
+ | |||
+ | 10.0.0.0/24 dev eth1 src 10.0.0.2 # connection to directly connected network 10.0.0.0/ | ||
+ | 192.168.100.0/ | ||
+ | 10.0.0.1 of the GL-iNet router | ||
+ | 192.168.200.0/ | ||
+ | |||
+ | </ | ||
+ | |||
+ | <code bash> | ||
+ | |||
+ | # | ||
+ | |||
+ | # | ||
+ | |||
+ | config interface ' | ||
+ | option type ' | ||
+ | option ifname ' | ||
+ | option proto ' | ||
+ | option ipaddr ' | ||
+ | option netmask ' | ||
+ | option ip6assign ' | ||
+ | |||
+ | # | ||
+ | |||
+ | config interface ' | ||
+ | option ifname ' | ||
+ | # | ||
+ | option proto ' | ||
+ | option ipaddr ' | ||
+ | option netmask ' | ||
+ | |||
+ | # | ||
+ | |||
+ | config route | ||
+ | option interface ' | ||
+ | option target ' | ||
+ | option netmask ' | ||
+ | option gateway ' | ||
+ | |||
+ | |||
+ | </code> | ||
+ | ===== Extracts ===== | ||
- | * Accomplished | ||
- | * Enable end-to-end communication | ||
- | * Analyse the addressing and routing (routing tables, DHCP, etc.) | ||
- | * Exceeded | ||
- | * Identify the necessary commands and configurations for enabling end-to-end communications |
qos_project.txt · Last modified: 2021/08/28 09:58 by samer