wikiroute

networking recipes

User Tools

Site Tools

Trace:
lab_with_ipv6_tunnel

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
lab_with_ipv6_tunnel [2018/01/19 14:56] – [3. Lab Platform Configuration] samerlab_with_ipv6_tunnel [2018/01/19 14:58] – [3.1. Static Configuration] samer
Line 42: Line 42:
 </code> </code>
 ==== -. Static Configuration ==== ==== -. Static Configuration ====
-On a PC in your lab, you can configure a static IPv6 address chosen from the /64 routed prefix (as shown on the Tunnel details information page). Moreover, you shroud add a default route using the link-local address of the interface e0 of TEP.+On a PC in your lab, you can configure a static IPv6 address chosen from your /64 routed prefix (as shown on the Tunnel details information page). Moreover, you should add a default route using the link-local address of the interface e0 of TEP as in the following:
 <code bash> <code bash>
 ip -6 addr add Routed_Prefix::X/64 dev PC_interface ip -6 addr add Routed_Prefix::X/64 dev PC_interface
 ip -6 route add default via TEP_e0_link_local_IPv6_addr ip -6 route add default via TEP_e0_link_local_IPv6_addr
 </code> </code>
- 
 ==== -. Stateless Auto-Configuration ==== ==== -. Stateless Auto-Configuration ====
  
lab_with_ipv6_tunnel.txt · Last modified: 2018/01/19 19:25 by samer