Differences

This shows you the differences between two versions of the page.

--- lab_with_ipv6_tunnel [2018/01/19 11:47] – [3.2. Stateless Auto-Configuration] samer
+++ lab_with_ipv6_tunnel [2018/01/19 14:57] – [3.1. Static Configuration] samer
@@ Line 37: / Line 37: @@
 Hurricane Electric has automatically assigned a /64 prefix to your account and routed it to the ''Client IPv6 Address''. You can retrieve the address on the tunnel details page under the ''Routed IPv6 Prefixes'' section. This prefix allows your TEP to operate as the router for this prefix and allows you to utilize static or automatic configuration  to hand out IPs from this allocation to your internal network. In the following, we will examine these two methods.
+In both cases, you should start by configuring a static IPv6 address on interface e0 of the TEP. This address should be chosen from the /64 prefix you are assigned.
 <code bash>
 ip -6 addr add Routed_Prefix::1/64 dev e0
 </code>
 ==== -. Static Configuration ====
-On a PC in your lab, you can configure a static IPv6 address chosen from the /64 routed prefix (as shown on the Tunnel details information page). Moreover, you shroud add a default route using the link-local address of the interface e0 of TEP.
+On a PC in your lab, you can configure a static IPv6 address chosen from the /64 routed prefix (as shown on the Tunnel details information page). Moreover, you should add a default route using the link-local address of the interface e0 of TEP.
 <code bash>
 ip -6 addr add Routed_Prefix::X/64 dev PC_interface