lab_with_ipv6_tunnel
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lab_with_ipv6_tunnel [2018/01/17 19:57] – [3.1. Static Configuration] samer | lab_with_ipv6_tunnel [2018/01/19 11:43] – [3.1. Static Configuration] samer | ||
---|---|---|---|
Line 41: | Line 41: | ||
</ | </ | ||
==== -. Static Configuration ==== | ==== -. Static Configuration ==== | ||
+ | On a PC in your lab, you can configure a static IPv6 address chosen from the /64 routed prefix (as shown on the Tunnel details information page). Moreover, you shroud add a default route using the link-local address of the interface e0 of TEP. | ||
+ | <code bash> | ||
+ | ip -6 addr add Routed_Prefix:: | ||
+ | ip -6 route add default via TEP_e0_link_local_IPv6_addr | ||
+ | </ | ||
==== -. Stateless Auto-Configuration ==== | ==== -. Stateless Auto-Configuration ==== | ||
+ | |||
+ | interface eth1 | ||
+ | { | ||
+ | AdvSendAdvert on; | ||
+ | prefix 2001: | ||
+ | { | ||
+ | AdvOnLink on; | ||
+ | AdvAutonomous on; | ||
+ | }; | ||
+ | }; | ||
+ | |||
+ | / |
lab_with_ipv6_tunnel.txt · Last modified: 2018/01/19 19:25 by samer