Differences

This shows you the differences between two versions of the page.

--- exploring_lorawan [2018/10/29 20:02] – [3. Devices] melhem
+++ exploring_lorawan [2018/11/27 11:06] – [5.1. The End-to-End Challenge] samer
@@ Line 13: / Line 13: @@
 [{{ :lora-pilot-architecture.png?direct&650 | Figure 1. Architecture of the LoRaWAN Platform}}]
+{{ :img_20170124_160141.jpg?nolink&400 | Outdoor antenna of ESIB}}
 <WRAP center round help 100%>
@@ Line 67: / Line 69: @@
 </WRAP>
-The LMIC library defines a set of events corresponding to the protocol machine state. These events appear in the ''onEvent()'' function.
+The LMIC library (see {{ :lmic-v1.5.pdf | documentation}}) defines a set of events corresponding to the protocol machine state. These events appear in the ''onEvent()'' function.
 <WRAP left round help 100%>
@@ Line 82: / Line 84: @@
 </WRAP>
-Now you are ready to compile the sketch and upload it to the LoRaWAN device. Connect the device a USB port on your PC, choose the board type as presented in [[exploring_lora|Exploring LoRa lab]] and select the corresponding port. Compile and upload!
+Now you are ready to compile the sketch and upload it to the LoRaWAN device. Connect the device to a USB port on your PC, choose the board type as presented in [[exploring_lora|Exploring LoRa lab]] and select the corresponding port. Compile and upload!
 Open the serial monitor in the Arduino IDE at 115200 baud and analyse the debug messages.
@@ Line 132: / Line 134: @@
 ==== -. The End-to-End Challenge ====
 I can send data from the device to the application.
+<WRAP center round tip 100%>
+Note that the `String` function can be used to cast the message you want to send in a string format.
+</WRAP>
 ==== -. The Downlink Challenge ====