exploring_lorawan
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
exploring_lorawan [2017/11/24 20:16] – [4. Applications] samer | exploring_lorawan [2017/11/24 20:37] – samer | ||
---|---|---|---|
Line 107: | Line 107: | ||
</ | </ | ||
===== -. Applications ===== | ===== -. Applications ===== | ||
- | mqtt-spy is an open source utility intended to help you with monitoring activity on MQTT topics. It has been designed to deal with high volumes of messages, as well as occasional publications. mqtt-spy is a JavaFX application, | + | mqtt-spy is an open source utility intended to help you with monitoring activity on MQTT topics. It has been designed to deal with high volumes of messages, as well as occasional publications. mqtt-spy is a JavaFX application, |
- | You can use mqtt-spy to debug the messages received from the LoRaWAN devices. The tool is provided at the beginning of the challenge. After starting the application, | + | |
+ | You can use mqtt-spy to debug the messages received from the LoRaWAN devices. After starting the application, | ||
<WRAP left round help 100%> | <WRAP left round help 100%> | ||
Line 121: | Line 122: | ||
</ | </ | ||
- | If you need to send data to your device, you should publish | + | If you need to send data to your device, you should publish |
< | < | ||
Line 135: | Line 136: | ||
The payload sent by the MQTT client must be encoded in Base64. | The payload sent by the MQTT client must be encoded in Base64. | ||
</ | </ | ||
- | ===== -. Day One Challenges ===== | + | ===== -. LoRaWAN |
+ | Implement and provide technical documentation for each of the following challenges. | ||
==== -. The End-to-End Challenge ==== | ==== -. The End-to-End Challenge ==== | ||
Line 144: | Line 146: | ||
==== -. The Radio Challenge ==== | ==== -. The Radio Challenge ==== | ||
- | I can tune the LoRa radio parameters | + | I can tune the LoRa radio parameters. |
These two commands can be helpful when used after the join event: | These two commands can be helpful when used after the join event: | ||
Line 152: | Line 154: | ||
LMIC_setDrTxpow(DR_SF12, | LMIC_setDrTxpow(DR_SF12, | ||
</ | </ | ||
+ | |||
==== -. The Sensor Challenge ==== | ==== -. The Sensor Challenge ==== | ||
I can use different sensors to send data from the device: PIR, moisture, temperature, | I can use different sensors to send data from the device: PIR, moisture, temperature, | ||
exploring_lorawan.txt · Last modified: 2021/11/02 06:31 by samer