Differences

This shows you the differences between two versions of the page.

--- exploring_lora [2018/10/06 14:02] – [4.3. [Classroom activity] Collisions and Packet Delivery Ratio] samer
+++ exploring_lora [2018/10/06 14:06] – samer
@@ Line 107: / Line 107: @@
 ==== -. Running Basic Sketches ====
-Now you can compile and upload the client and server sketches on the two arduino devices, respectively. On the serial interfaces, you should obtain similar results as in Fig. 2 and Fig. 3. The client sends periodically a short message towards the server. The server outputs the RSSI (received power in dBm) for each received message.
+Now you can compile and upload the client and server sketches on the two arduino devices, respectively. On the serial interfaces, you should obtain similar results as in Fig. 2 and Fig. 3. The client sends periodically a short packet towards the server. The server outputs the RSSI (received power in dBm) for each received packet.
 [{{ :client-iotlab1.png?direct&600 ||Figure 2. Client serial monitor}}]
@@ Line 117: / Line 117: @@
 ==== -. Time on Air ====
-In this section, you will measure the Time on Air (ToA) that is given by the time necessary to transmit a message on the radio interface. You will assess the impact of the spreading factor, bandwidth, coding rate, and message size on the ToA.
+In this section, you will measure the Time on Air (ToA) that is given by the time necessary to transmit a packet on the radio interface. You will assess the impact of the spreading factor, bandwidth, coding rate, and packet size on the ToA.
-Start by implementing a function on the client that measures the time necessary for sending a message. You can have recourse to the [[https://www.arduino.cc/en/Reference/Micros| micros()]] function available in the arduino libraries. Now, you can modify one of the parameters (spreading factor, bandwidth, coding rate, message size) and record the impact on the ToA. Note well that you may need to repeat the experiment multiple times in order to obtain the statistical distribution.
+Start by implementing a function on the client that measures the time necessary for sending a packet. You can have recourse to the [[https://www.arduino.cc/en/Reference/Micros| micros()]] function available in the arduino libraries. Now, you can modify one of the parameters (spreading factor, bandwidth, coding rate, packet size) and record the impact on the ToA. Note well that you may need to repeat the experiment multiple times in order to obtain the statistical distribution.
-For example, the scenario for assessing the impact of the spreading factor on the ToA consists of sending 100 messages for three different spreading factors //e.g.,// 7, 9, and 10, and drawing the average ToA or the distribution in a boxplot for comparing the results.
+For example, the scenario for assessing the impact of the spreading factor on the ToA consists of sending 100 packets for three different spreading factors //e.g.,// 7, 9, and 10, and drawing the average ToA or the distribution in a boxplot for comparing the results.
 <WRAP center round help 100%>
@@ Line 148: / Line 148: @@
   * Only one server is required in the classroom. This server should compute the ratio of successfully delivered packets or PDR.
   * All groups are required to use the same frequency, spreading factor, and coding rate.
-  * On each client, packets will be generated following a Poisson process with the same average arrival rate for all groups.
+  * On each client, the same average arrival rate for all groups.
 <WRAP center round help 100%>