Differences

This shows you the differences between two versions of the page.

--- exploring_lora [2018/10/04 17:36] – [2. Theoretical Study] melhem
+++ exploring_lora [2018/10/04 17:43] – [2. Theoretical Study] melhem
@@ Line 58: / Line 58: @@
   * How does the spreading factor impact the coverage of a LoRa transmitter?
   * What is the transmission bit rate for each of the following configurations of your LoRa device? Explain your computation.
-  ** Configuration 1: channel bandwidth = 125 kHz, spreading factor = 7, coding rate = 4/5.
+    * Configuration 1: channel bandwidth = 125 kHz, spreading factor = 7, coding rate = 4/5.
-  ** Configuration 2: channel bandwidth = 500 kHz, spreading factor = 7, coding rate = 4/5.
+    * Configuration 2: channel bandwidth = 500 kHz, spreading factor = 7, coding rate = 4/5.
-  ** Configuration 3: channel bandwidth = 125 kHz, spreading factor = 12, coding rate = 1/2.
+    * Configuration 3: channel bandwidth = 125 kHz, spreading factor = 12, coding rate = 1/2.
   * Compute the receiver sensitivity, assuming the following parameters: channel bandwidth = 125 kHz, spreading factor = 7, coding rate = 4/5, bit error rate (BER) target = 10<sup>-4</sup>, and receiver noise figure = 6 dB. Refer to this {{ :1705.05899.pdf | article}} to determine the mapping between the BER and the SNR.
   * Compare the computed sensitivity to that provided by the {{ :an1200.22.pdf |Semtech Application Note AN1200.22}} for the same parameters.