Differences

This shows you the differences between two versions of the page.

--- exploring_lora [2018/09/30 10:33] – [4.2. Coverage] samer
+++ exploring_lora [2018/10/04 17:44] – [2. Theoretical Study] melhem
@@ Line 57: / Line 57: @@
   * What is the relation between processing gain and spreading factor in LoRa modulation? Explain.
   * How does the spreading factor impact the coverage of a LoRa transmitter?
-  * For each of the three possible configurations of your LoRa device, what is the transmission bit rate? Explain your computation.
+  * What is the transmission bit rate for each of the following configurations of your LoRa device? Explain your computation.
+    * Configuration 1: channel bandwidth = 125 kHz, spreading factor = 7, coding rate = 4/5
+    * Configuration 2: channel bandwidth = 500 kHz, spreading factor = 7, coding rate = 4/5
+    * Configuration 3: channel bandwidth = 125 kHz, spreading factor = 12, coding rate = 1/2
   * Compute the receiver sensitivity, assuming the following parameters: channel bandwidth = 125 kHz, spreading factor = 7, coding rate = 4/5, bit error rate (BER) target = 10<sup>-4</sup>, and receiver noise figure = 6 dB. Refer to this {{ :1705.05899.pdf | article}} to determine the mapping between the BER and the SNR.
   * Compare the computed sensitivity to that provided by the {{ :an1200.22.pdf |Semtech Application Note AN1200.22}} for the same parameters.