exploring_lora
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
exploring_lora [2018/09/29 15:33] – samer | exploring_lora [2018/09/29 15:35] – [4.3. Coverage] samer | ||
---|---|---|---|
Line 146: | Line 146: | ||
==== -. Coverage ==== | ==== -. Coverage ==== | ||
- | In this section, you will measure the coverage of LoRa devices | + | In this section, you will measure the coverage of LoRa under the three different radio configurations. |
+ | |||
+ | For this, you will start by identifying a set of Test Points (TP). Then, you should implement a function that sends packets with different radio configurations. Note that the following functions in the Arduino sketch enable to modify //on the fly// the LoRa parameters: | ||
<code c++> | <code c++> | ||
Line 158: | Line 160: | ||
* Give a statistical measure of the PER and the RSSI for each TP with each of the different radio configurations. | * Give a statistical measure of the PER and the RSSI for each TP with each of the different radio configurations. | ||
</ | </ | ||
- | |||
==== -. Path Loss ==== | ==== -. Path Loss ==== | ||
exploring_lora.txt · Last modified: 2021/10/20 12:52 by samer