Differences

This shows you the differences between two versions of the page.

--- exploring_lora [2018/09/29 12:31] – [3.1. Modifying the Radio Parameters] samer
+++ exploring_lora [2018/09/29 12:51] – [3.1. Modifying the Radio Parameters] samer
@@ Line 67: / Line 67: @@
 ==== -. Modifying the Radio Parameters ====
-Download the {{ :sketch-1819.zip | basic sketches}} that implement a simple LoRa communication between the two modules: a client module and a server module. Open the sketches with Arduino IDE. Make sure to choose the correct ''Board'' and ''Port'' in the ''Tools'' menu.
+Download the {{ :sketch-1819.zip | basic sketches}} that implement a simple LoRa communication between the two modules: a client module and a server module. Open the sketches with Arduino IDE. Make sure to choose the correct ''Board'' and ''Port'' in the ''Tools'' menu. In order to reduce collisions, configure the central frequency of your LoRa modules as below:
-The typical configuration for LoRa modules consists of 125 kHz sub-channels, a coding rate of 4/5, and a spreading factor equal to 7. You can later modify these radio parameters in the ''setup'' function by choosing one the following data rates:
-^  Data Rate   ^  Spreading Factor      ^  Bandwidth  ^
-|  DR0         |	SF12            |  125kHz   |
-|  DR1         |	SF11            |  125kHz   |
-|  DR2         |	SF10            |  125kHz   |
-|  DR3         |	SF9             |  125kHz   |
-|  DR4         |	SF8             |  125kHz   |
-|  DR5         |	SF7             |  125kHz   |
-|  DR6         |	SF7             |  250kHz   |
-In order to reduce collisions, configure the central frequency of your LoRa modules as below:
 ^  Group Number  ^   Frequency     ^
@@ Line 96: / Line 83: @@
 |       12       |      868.9      |
+Note that the radio parameters of your LoRa devices: Spreading Factor (SF), Bandwidth (Bw), and Coding Rate (CR) are configured in the ''setup'' function of the sketches. when needed, you can modify these configurations.
 ==== -. Running Basic Sketches ====