Differences

This shows you the differences between two versions of the page.

--- exploring_lora [2018/09/29 11:38] – [3.1. Modifying the Radio Parameters] samer
+++ exploring_lora [2018/09/29 11:43] – [3.1. Modifying the Radio Parameters] samer
@@ Line 67: / Line 67: @@
 ==== -. Modifying the Radio Parameters ====
-Download the {{ :sketch-1819.zip | basic sketches}} that implement a simple LoRa communication between the two modules. Open the sketches with Arduino IDE.
+Download the {{ :sketch-1819.zip | basic sketches}} that implement a simple LoRa communication between the two modules: a client module and a server module. Open the sketches with Arduino IDE. Make sure to choose the correct ''Board'' and ''Port'' in the ''Tools'' menu.
 Start by setting the central frequency of your LoRa modules according to the following table:
@@ Line 86: / Line 86: @@
-The typical configuration for LoRa modules consists of 125 kHz sub-channels, a coding rate of 4/5, and a spreading factor equal to 7. You can modify the radio parameters by selecting one of the three available configurations:
+The typical configuration for LoRa modules consists of 125 kHz sub-channels, a coding rate of 4/5, and a spreading factor equal to 7. You can also modify these radio parameters in the ''setup'' function.
 ==== -. Running Basic Sketches ====