wikiroute

networking recipes

User Tools

Site Tools

Trace:
exploring_lora

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
exploring_lora [2018/09/27 11:56] – [3.1. Modifying the Radio Parameters] samerexploring_lora [2018/09/27 14:49] – [3.1. Modifying the Radio Parameters] samer
Line 67: Line 67:
 ==== -. Modifying the Radio Parameters ==== ==== -. Modifying the Radio Parameters ====
  
-Start by setting the central frequency of the LoRa modules. For this, open the ''RH_RF95.cpp'' file locate in the ''RadioHead'' folder and change the frequency according to the following table:+Start by setting the central frequency of your LoRa modules according to the following table:
  
 ^  Group Number  ^   Frequency     ^ ^  Group Number  ^   Frequency     ^
Line 82: Line 82:
 |       11       |      868.7      | |       11       |      868.7      |
 |       12       |      868.9      | |       12       |      868.9      |
 +
 +For this, open the ''RH_RF95.cpp'' file located in the ''RadioHead'' folder and change the frequency using the following command:
  
 <file cpp RH_RF95.cpp> <file cpp RH_RF95.cpp>
Line 119: Line 121:
  
  
-==== -. Packet Error Rate ====+==== -. Packet Delivery Ratio ====
  
 In this section, you will measure the Packet Error Rate (PER) under the three different radio configurations and for different transmission periods. For this, you can start by implementing a function on the client that measures the ratio of successfully delivered packets.  In this section, you will measure the Packet Error Rate (PER) under the three different radio configurations and for different transmission periods. For this, you can start by implementing a function on the client that measures the ratio of successfully delivered packets. 
exploring_lora.txt · Last modified: 2021/10/20 12:52 by samer