exploring_lora
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
exploring_lora [2018/09/27 11:56] – samer | exploring_lora [2018/09/27 14:50] – [3.1. Modifying the Radio Parameters] samer | ||
---|---|---|---|
Line 67: | Line 67: | ||
==== -. Modifying the Radio Parameters ==== | ==== -. Modifying the Radio Parameters ==== | ||
- | Start by setting the central frequency of the LoRa modules. For this, open the '' | + | Start by setting the central frequency of your LoRa modules according to the following table: |
- | ^ | + | ^ Group Number |
| | | | ||
| | | | ||
Line 82: | Line 82: | ||
| | | | ||
| | | | ||
+ | |||
+ | For this, open the '' | ||
<file cpp RH_RF95.cpp> | <file cpp RH_RF95.cpp> | ||
- | setFrequency(868.X); | + | setFrequency(86X.Y); |
</ | </ | ||
Line 119: | Line 121: | ||
- | ==== -. Packet | + | ==== -. Packet |
In this section, you will measure the Packet Error Rate (PER) under the three different radio configurations and for different transmission periods. For this, you can start by implementing a function on the client that measures the ratio of successfully delivered packets. | In this section, you will measure the Packet Error Rate (PER) under the three different radio configurations and for different transmission periods. For this, you can start by implementing a function on the client that measures the ratio of successfully delivered packets. |
exploring_lora.txt · Last modified: 2021/10/20 12:52 by samer