Differences

This shows you the differences between two versions of the page.

--- esib_iot_challenge [2017/05/17 14:50] – [1. What is a LoRaWAN Platform?] samer
+++ esib_iot_challenge [2017/05/17 15:37] – [2. Devices] samer
@@ Line 14: / Line 14: @@
 [{{ :lora-pilot-architecture.png?direct&650 | Figure 1. Architecture of the LoRaWAN Platform}}]
-<WRAP center help 100%>
+<WRAP left help 100%>
   * Where is the LoRa modulation implemented on the platform?
   * What are the advantages of the LoRa modulation?
@@ Line 25: / Line 25: @@
 ===== -. Devices =====
-In orde to program the LoRaWAN devices, you should verify the installation one your PC of the following software:
+Devices in the LoRaWAN platform are implemented on Arduino boards with Dragino shields. The combined module as well as the basic configuration steps are presented in [[simple_lora_prototype|Simple Prototype of LoRa Communications]].
-  * Arduino IDE
+Start by verifying the installation on your PC of the latest Arduino IDE and place the Arduino LMIC library in the corresponding folder.
-  * LMIC Library
-Devices in the LoRaWAN platform are implemented on Arduino boards with Dragino shields. The combined module as well as the basic configuration steps are presented in [[simple_lora_prototype|Simple Prototype of LoRa Communications]]. You can download the following sketch {{ :test-loraserver-comb-loraserver-dragino.zip |}} and modify it according to your preferences. Below you can find somme commented extracts of the sketch.
+<WRAP left round help 100%>
+  * Give the characteristics of the Arduino you are using: number of pins, type of pins, memory sizes, etc.
+  * Give the main characteristics of the LoRa shield from Dragino (www.dragino.com).
+  * What type of Antenna are you using? Explain the corresponding characteristics.
+</WRAP>
+Download the example sketch, open it with Arduino IDE and compile it.
+You can download the following sketch {{ :test-loraserver-comb-loraserver-dragino.zip |}} and modify it according to your preferences. Below you can find somme commented extracts of the sketch.
+Verify that you have the latest Arduino IDE from https://www.arduino.cc/en/Main/Software on your computer.
+Install the board files as noted in http://support.sodaq.com/sodaq-one/autonomо/getting-started-autonomo/.
+Add the following library sodaq_rn2483_2.zip to your Arduino IDE as explained in https://www.arduino.cc/en/guide/libraries.
+In order to program the LoRaWAN devices, you should verify the installation one your PC of the following software:
+  * Arduino IDE
+  * LMIC Library
+  *
 The pin mapping corresponds to the Dragino electronic schematic:
 <code c++>
@@ Line 76: / Line 93: @@
   * Security
 </WRAP>
 ===== -. Backend =====
 The Loraserver has a web interface for configuring the applications and devices on the platform. Full details for installing the software are provided on [[https://www.loraserver.io]].