Differences

This shows you the differences between two versions of the page.

--- esib_iot_challenge [2017/05/17 09:36] – [2.1. Arduino with Dragino Shield] samer
+++ esib_iot_challenge [2017/05/17 10:24] – [2.2. Arduino with Dragino Shield] samer
@@ Line 23: / Line 23: @@
 ==== -. Arduino with Dragino Shield ====
-=== -. Periodic Message Sending ===
 Devices in the LoRaWAN platform are implemented on Arduino boards with Dragino shields. The combined module as well as the basic configuration steps are presented in [[simple_lora_prototype|Simple Prototype of LoRa Communications]]. You can download the following sketch {{ :test-loraserver-comb-loraserver-dragino.zip |}} and modify it according to your preferences. Below you can find somme commented extracts of the sketch.
@@ Line 57: / Line 56: @@
 </code>
-The message containing the sensor values is transmitted on one of the radio channels (as in the Autonomo case):
+The message containing the sensor values is transmitted on one of the radio channels:
 <code c++>
 LMIC_setTxData2(1, (uint8_t*) buffer, message.length() , 0);
-</code>
-The adaptive data rate is not supported, and the spreading factor is configured as follows:
-<code c++>
-LMIC_setDrTxpow(DR_SF7,14);
 </code>