deploying_lorawan
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
deploying_lorawan [2017/04/30 14:37] – [1.1. Autonomo with LoRaBee] samer | deploying_lorawan [2017/04/30 16:19] – [Deploying an End-to-End LoRaWAN Platform] samer | ||
---|---|---|---|
Line 3: | Line 3: | ||
Starting from September 2016, Saint-Joseph University of Beirut (USJ) will be deploying the first academic [[http:// | Starting from September 2016, Saint-Joseph University of Beirut (USJ) will be deploying the first academic [[http:// | ||
- | [{{ :e2e-lorawan.png? | + | [{{ :lora-pilot-architecture.jpg? |
===== -. Devices ===== | ===== -. Devices ===== | ||
Line 65: | Line 65: | ||
==== -. Arduino with Dragino Shield ==== | ==== -. Arduino with Dragino Shield ==== | ||
- | Devices in the LoRaWAN platform can also be used on Arduino boards with Dragino shields. The combined module as well as the basic configuration steps are presented in [[simple_lora_prototype|Simple Prototype of LoRa Communications]]. As for the Autonomo device, you can download the following sketch {{ : | + | Devices in the LoRaWAN platform can also be implemented |
- | Do not forget | + | The pin mapping corresponds |
<code c++> | <code c++> | ||
const lmic_pinmap lmic_pins = { | const lmic_pinmap lmic_pins = { | ||
Line 77: | Line 77: | ||
</ | </ | ||
- | The send function is called upon after each transmission complete event: | + | The send function is rescheduled TX_INTERVAL seconds |
<code c++> | <code c++> | ||
case EV_TXCOMPLETE: | case EV_TXCOMPLETE: | ||
Line 92: | Line 92: | ||
</ | </ | ||
- | This is explicitly the send function | + | This send function |
<code c++> | <code c++> | ||
- | LMIC_setTxData2(1, (uint8_t*) buffer, message.length() , 0); | + | do_send(& |
</ | </ | ||
- | You can modify | + | The message containing |
<code c++> | <code c++> | ||
- | LMIC_setDrTxpow(DR_SF7,14); | + | LMIC_setTxData2(1, (uint8_t*) buffer, message.length() , 0); |
</ | </ | ||
- | Schedule | + | The adaptive data rate is not supported, and the spreading factor is configured as follows: |
<code c++> | <code c++> | ||
- | do_send(& | + | LMIC_setDrTxpow(DR_SF7,14); |
</ | </ | ||
===== -. Gateways ===== | ===== -. Gateways ===== |
deploying_lorawan.txt · Last modified: 2021/08/28 09:50 by samer