Differences

This shows you the differences between two versions of the page.

--- deploying_lorawan [2017/04/30 13:26] – [1.2. Arduino with Dragino Shield] samer
+++ deploying_lorawan [2017/04/30 14:19] – [1.2. Arduino with Dragino Shield] samer
@@ Line 66: / Line 66: @@
 ==== -. Arduino with Dragino Shield ====
-Devices in the LoRaWAN platform can also be used on Arduino boards with Dragino shields. The combined module as well as the basic configuration steps are presented in [[simple_lora_prototype|Simple Prototype of LoRa Communications]]. As for the Autonomo device, you can download the following sketch {{ :test-loraserver-comb-loraserver-dragino.zip |}} and modify it according to your preferences. Here are some extracts of the sketch:
+Devices in the LoRaWAN platform can also be used on Arduino boards with Dragino shields. The combined module as well as the basic configuration steps are presented in [[simple_lora_prototype|Simple Prototype of LoRa Communications]]. As for the Autonomo device, you can download the following sketch {{ :test-loraserver-comb-loraserver-dragino.zip |}} and modify it according to your preferences. Below you can find somme commented extracts of the sketch.
-Do not forget to insert you keys for the OTAA join method.
+Do not forget to insert you keys for the OTAA join method:
 <code c++>
 const lmic_pinmap lmic_pins = {
@@ Line 79: / Line 78: @@
 </code>
+The send function is called upon after each transmission complete event:
 <code c++>
         case EV_TXCOMPLETE:
@@ Line 93: / Line 93: @@
 </code>
+This is explicitly the send function of the message containing the sensor values (as in the Autonomo case):
 <code c++>
 LMIC_setTxData2(1, (uint8_t*) buffer, message.length() , 0);
 </code>
+You can modify the spreading factor here (Adaptive data rate is not supported):
 <code c++>
 LMIC_setDrTxpow(DR_SF7,14);
 </code>
+Schedule the send function:
 <code c++>
 do_send(&sendjob);