wikiroute

networking recipes

User Tools

Site Tools

Trace:
deploying_lorawan

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
deploying_lorawan [2017/04/29 18:04] – [1.1. Autonomo with LoRaBee] samerdeploying_lorawan [2017/04/29 18:44] – [1.1. Autonomo with LoRaBee] samer
Line 16: Line 16:
     - Add the following library {{ :sodaq_rn2483_2.zip |}} to your Arduino IDE as explained in [[https://www.arduino.cc/en/guide/libraries]].     - Add the following library {{ :sodaq_rn2483_2.zip |}} to your Arduino IDE as explained in [[https://www.arduino.cc/en/guide/libraries]].
  
-Now you are ready to write a sketch for the device.+Now you are ready to write a sketch for the device. Here is one example sketch {{ :test-lorawan-combined-loraserver-example.zip |}} with the following features: 
 + 
 +  * Three sensors connected to the Autonomo on pins A0 (light sensor), A2 (moisture sensor), and D0 (temperature sensor). 
 +  * OTA join method 
 +  * Frequency channels 
 +  * Message sending 
 + 
 ==== -. Arduino with Dragino Shield ==== ==== -. Arduino with Dragino Shield ====
  
deploying_lorawan.txt · Last modified: 2021/08/28 09:50 by samer