deploying_lorawan
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
deploying_lorawan [2017/04/29 17:45] – [1. End-nodes] samer | deploying_lorawan [2017/04/29 18:04] – [1.1. Autonomo with LoRaBee] samer | ||
---|---|---|---|
Line 8: | Line 8: | ||
==== -. Autonomo with LoRaBee ==== | ==== -. Autonomo with LoRaBee ==== | ||
- | For the end-devices in the LoRaWAN platform, we will use an Autonomo board with a LoRaBee holding the Microchip RN2483 module. According to [[http:// | + | For the devices in the LoRaWAN platform, we will use an Autonomo board with a LoRaBee holding the Microchip RN2483 module. According to [[http:// |
- | In order to configure the end- | + | In order to configure the Autonomo with LoRaBee device, you should follow these steps: |
+ | |||
+ | | ||
+ | - Install the board files as noted in [[http:// | ||
+ | - Add the following library {{ : | ||
+ | |||
+ | Now you are ready to write a sketch for the device. | ||
==== -. Arduino with Dragino Shield ==== | ==== -. Arduino with Dragino Shield ==== | ||
deploying_lorawan.txt · Last modified: 2021/08/28 09:50 by samer