Differences

This shows you the differences between two versions of the page.

--- deploying_lorawan [2017/04/29 17:45] – [1. End-nodes] samer
+++ deploying_lorawan [2017/04/29 17:51] – [1.1. Autonomo with LoRaBee] samer
@@ Line 8: / Line 8: @@
 ==== -. Autonomo with LoRaBee ====
-For the end-devices in the LoRaWAN platform, we will use an Autonomo board with a LoRaBee holding the Microchip RN2483 module. According to [[http://shop.sodaq.com]], Autonomo is a matchbox-sized powerhouse which uses the new Atmel Cortex M0+ 32bit micro controller. It can be powered by a smartphone-sized solar panel.
+For the devices in the LoRaWAN platform, we will use an Autonomo board with a LoRaBee holding the Microchip RN2483 module. According to [[http://shop.sodaq.com]], Autonomo is a matchbox-sized powerhouse which uses the new Atmel Cortex M0+ 32bit micro controller. One advantage of such device is that it can be powered by a smartphone-sized solar panel.
-In order to configure the end-
+In order to configure the device, you need to install the Arduino IDE from [[https://www.arduino.cc/en/Main/Software]]. Then you need to to install the board files as noted in [[http://support.sodaq.com/sodaq-one/autonomо/getting-started-autonomo/]].
+{{ :sodaq_rn2483_2.zip |}}
 ==== -. Arduino with Dragino Shield ====