deploying_lorawan
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
deploying_lorawan [2017/04/29 17:45] – [1.1. Autonomo with LoRaBee] samer | deploying_lorawan [2017/04/29 17:51] – [1.1. Autonomo with LoRaBee] samer | ||
---|---|---|---|
Line 5: | Line 5: | ||
[{{ : | [{{ : | ||
- | ===== -. End-nodes | + | ===== -. Devices |
==== -. Autonomo with LoRaBee ==== | ==== -. Autonomo with LoRaBee ==== | ||
- | For the end-devices in the LoRaWAN platform, we will use an Autonomo board with a LoRaBee holding the Microchip RN2483 module. According to [[http:// | + | For the devices in the LoRaWAN platform, we will use an Autonomo board with a LoRaBee holding the Microchip RN2483 module. According to [[http:// |
- | In order to configure the end- | + | In order to configure the device, you need to install the Arduino IDE from [[https:// |
+ | |||
+ | {{ : | ||
==== -. Arduino with Dragino Shield ==== | ==== -. Arduino with Dragino Shield ==== | ||
deploying_lorawan.txt · Last modified: 2021/08/28 09:50 by samer