deploying_lorawan
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
deploying_lorawan [2017/01/05 10:27] – [2.1. Single Channel Gateway] samer | deploying_lorawan [2017/04/29 17:45] – [1. End-nodes] samer | ||
---|---|---|---|
Line 5: | Line 5: | ||
[{{ : | [{{ : | ||
- | ===== -. End-nodes | + | ===== -. Devices |
==== -. Autonomo with LoRaBee ==== | ==== -. Autonomo with LoRaBee ==== | ||
+ | For the end-devices in the LoRaWAN platform, we will use an Autonomo board with a LoRaBee holding the Microchip RN2483 module. According to [[http:// | ||
+ | |||
+ | In order to configure the end- | ||
==== -. Arduino with Dragino Shield ==== | ==== -. Arduino with Dragino Shield ==== | ||
Line 42: | Line 45: | ||
</ | </ | ||
- | For gcc version 4.6.3, a compilation error results in the following warning '' | + | For gcc version 4.6.3, a compilation error results in the following warning '' |
< | < | ||
CFLAGS = -std=c++0x -c -Wall -I include/ | CFLAGS = -std=c++0x -c -Wall -I include/ | ||
</ | </ | ||
- | Now, you need to configure the single channel packet forwarder. This is done in the '' | + | Now, you need to configure the single channel packet forwarder. This is done in the '' |
- | <file global_config.json> | + | < |
{ | { | ||
" | " | ||
Line 92: | Line 95: | ||
</ | </ | ||
- | and run the packet forwarder as root. | + | Finally, you can run the packet forwarder as root! |
<code bash> | <code bash> |
deploying_lorawan.txt · Last modified: 2021/08/28 09:50 by samer