Differences

This shows you the differences between two versions of the page.

--- deploying_lorawan [2016/12/20 11:00] – [2.1. Single Channel Gateway] samer
+++ deploying_lorawan [2016/12/20 12:24] – [2.1. Single Channel Gateway] samer
@@ Line 17: / Line 17: @@
 [{{ :schema-pins-pi3.png?direct&300 |Figure 3. Raspberry pi 3 pins}}]
-SPI needs to be enabled on the Raspberry Pi (use raspi-config)
+After making the correct connection, you need to install the packet forwarder software on the Raspberry Pi. The source code is available on: [[https://github.com/samerlahoud/single_chan_pkt_fwd]]. In order to proceed, you need to :
-WiringPi: a GPIO access library written in C for the BCM2835 used in the Raspberry Pi. sudo apt-get install wiringpi see http://wiringpi.com
+  * Enable SPI on the Raspberry Pi using raspi-config
-Run packet forwarder as root
+  * Download and unzip the source code:
+<code bash>
+wget https://github.com/hallard/single_chan_pkt_fwd/archive/master.zip
+unzip master.zip
+</code>
+  * Install the wiring library:
+<code bash>
+apt-get update
+apt-get install wiring
+</code>
+  * Compile and run the packet forwarder as root.
+gcc version 4.6.3
+unrecognized command line option '-std=c++11'
+CFLAGS = -std=c++0x -c -Wall -I include/
 ==== -. Kerlink IoT Station ====