deploying_lorawan
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
deploying_lorawan [2016/12/20 10:50] – samer | deploying_lorawan [2016/12/20 11:18] – [2.1. Single Channel Gateway] samer | ||
---|---|---|---|
Line 4: | Line 4: | ||
[{{ : | [{{ : | ||
- | [{{ : | ||
===== -. End-nodes ===== | ===== -. End-nodes ===== | ||
Line 14: | Line 13: | ||
==== -. Single Channel Gateway ==== | ==== -. Single Channel Gateway ==== | ||
- | The single channel gateway includes a LoRa transmission module (the Dragino Shield) connected to a Raspberry Pi (2 or 3). | + | The single channel gateway includes a LoRa transmission module (the Dragino Shield) connected to a Raspberry Pi (2 or 3). The connection pins are identified in Figures 2 and 3. Communication is done on an SPI communication interface. |
[{{ : | [{{ : | ||
+ | [{{ : | ||
+ | |||
+ | After making the correct connection, you need to install the packet forwarder software on the Raspberry Pi. The source code is available on: [[https:// | ||
+ | * Enable SPI on the Raspberry Pi using raspi-config | ||
+ | * Download and unzip the source code: | ||
+ | |||
+ | <code bash> | ||
+ | wget https:// | ||
+ | unzip master.zip | ||
+ | </ | ||
+ | |||
+ | * Install the wiring library: | ||
+ | |||
+ | <code bash> | ||
+ | apt-get update | ||
+ | apt-get install wiring | ||
+ | </ | ||
+ | |||
+ | * Compile and run the packet forwarder as root. | ||
==== -. Kerlink IoT Station ==== | ==== -. Kerlink IoT Station ==== | ||
deploying_lorawan.txt · Last modified: 2021/08/28 09:50 by samer